Addonics Technologies SCHD SA-FW Manual de usuario descargar pdf (Pagina 251)

Administering Communication Manager

Issue 12 May 2009

251

IP Interfaces Screen

2. The field Enable Ethernet? should indicate y (yes). The Node Name should be the IP

address of the S8300 Server.

3. In the Allow H.323 Endpoints field, enter a ’y’ to allow H.323 endpoint connectivity to the

server.

4. In the Allow H.248 Endpoints field, enter a ’y’ to allow H.248 media gateway connectivity

to the server.

5. In the Gatekeeper Priority field, enter a value is used on the alternate gatekeeper list. The

lower the number the higher the priority. Valid values for this field are one through nine with

five being the default. This field displays only if the allow H.323 endpoints field is set to y.

6. In the Target Socket Load field, enter the maximum number of sockets targeted for this

interface. The default is 80% of the maximum of 2000. When all the IP interfaces within the

same Gatekeeper Priority exceeds the target number that you allocate, the system

continues to add sockets until the interface is at its maximum capacity.

Identifying LSPs to the S8300 primary controller

If the primary controller has LSPs, you must enter the LSP node names on the Survivable

Processor form to enable the LSPs to get translations updates from the primary controller. Once

the LSPs are successfully entered on the survivable-processor screen, their status can be

viewed with the list survivable-processor command.

Note:

Note: The LSP node names must be administered on the node-names-ip form before

they can be entered on the Survivable Processor screen.

1. At the SAT command line, type add survivable-processor <name>, where <name>

is the LSP name from the Node Names screen.

The Survivable Processor screen appears.

change ip-interface procr Page 1 of 1

IP INTERFACES

Type: PROCR

Target socket load: 1700

Enable Interface? y Allow H.323 Endpoints? y

Allow H.248 Gateways? y

Network Region: 1 Gatekeeper Priority: 5

IPV4 PARAMETERS

Node Name: procr

Subnet Mask: /19

1 2 ... 246 247 248 249 250 251 252 253 254 255 256 ... 407 408

Sin comentarios

Addonics Technologies SCHD SA-FW Manual de usuario Pagina 251